Skip to content

Mass Save Contractors in Boston, MA

By MassHVAC Editorial Team Reviewed by MassHVAC Editorial Team Last updated

What makes a Boston contractor Mass Save qualified

A Mass Save contractor in Boston must hold a Massachusetts Refrigeration Technician (RT) license and be enrolled in the Mass Save Heat Pump Installer Network (HPIN). The RT license is what makes the install legal in the Commonwealth; HPIN enrollment is what makes it rebate-eligible. Both gates have to be cleared — qualifying equipment installed by a non-HPIN contractor still forfeits the rebate.

Who processes your rebate in Boston

Mass Save in Boston is administered through Eversource (electric) and National Grid (gas). That sponsor processes the heat pump rebate your HPIN contractor files (up to $8,500 standard in 2026, or up to $16,000 enhanced for income-qualified households) and the 0% HEAT Loan referral. You can verify your account sponsor in the Mass Save sponsors directory.

Note: Boston Gas Company d/b/a National Grid.

Permits in Boston

A qualified Boston contractor pulls the mechanical permit — and, for any gas work, a separate gas permit — through the Inspectional Services Department (ISD), Building Division on your behalf. If an installer asks you to pull your own permit, treat it as a red flag: it usually means they are not licensed to do the work in Boston.

The Back Bay Architectural Commission and Beacon Hill Architectural Commission both require approval for HVAC condensers and mini-split heads visible from any public way; rooftop placement set well back from cornices is the typical approved location for those neighborhoods.

Verify before you sign in Boston

Why hiring outside HPIN costs a Boston homeowner up to $8,500

The Mass Save whole-home rebate — $2,650 per ton, capped at $8,500 per home in 2026 — can only be filed by an HPIN-enrolled contractor. A licensed but non-HPIN installer in Boston cannot file it, so you forfeit the full rebate even when the equipment itself qualifies. The federal §25C and §25D tax credits expired December 31, 2025, which makes the Mass Save rebate the primary incentive left on the table — and the reason the installer's network status matters as much as the equipment.

Massachusetts incentives

2026 Mass Save rebates your Boston contractor files

See the full Mass Save rebates hub

Verified 2026-09-19

Most homes

Whole-Home Heat Pump Rebate

$2,650 /ton

Capped at $8,500 per home

The installed heat pump must be the sole source of heating and cooling for the spaces served. Equipment must be ENERGY STAR Cold Climate certified and listed on the Mass Save Heat Pump Qualified Products List (HPQPL). A Manual J load calculation is needed to qualify for the sizing bonus and is industry-standard practice on Mass Save projects.

Partial-Home / Supplemental Heat Pump Rebate

$1,125 /ton

Capped at $8,500 per home

Heat pump installed alongside an existing primary heating system. Equipment must be on the HPQPL. Lower per-ton rebate reflects supplemental rather than sole-source use.

Basic Heat Pump Rebate

$250 /ton

Capped at $2,500 per home

New for 2026. Applies to replacing an existing heat pump with a new qualified HPQPL-listed heat pump, or conditioning a previously unconditioned space.

+

$500 Right-Sized Equipment Bonus Partial-home

Partial-home installs only. Equipment must be sized to meet 90–120% of the total heating load at the outdoor design temperature, documented via an ACCA Manual J load calculation submitted with the rebate application.

+

$500 Weatherization Bonus Partial-home

Partial-home installs only. Requires a Mass Save Home Energy Assessment plus installation of the recommended weatherization (typically air sealing and insulation) within one year prior to or up to six months after the heat pump installation.

Financing

Mass Save HEAT Loan

0% APR up to $25,000

  • Below 135% of State Median Income: 7 years (84 months)
  • 135%–300% of State Median Income: 5 years (60 months)
  • Over 300% of State Median Income: 3 years (36 months)

Subject to bank underwriting through participating Massachusetts lenders. Covers equipment + installation costs for qualifying high-efficiency upgrades (heat pumps, ductless mini-splits, insulation, water heaters, and batteries enrolled in ConnectedSolutions). A Home Energy Assessment is mandatory before financing a whole-home heat pump. Households below approximately 81% SMI typically route to Mass Save's no-cost / enhanced-rebate programs rather than the HEAT Loan.

No federal heat pump tax credit applies in 2026.

  • Section 25C Energy Efficient Home Improvement Credit (heat pump portion) (30% of cost up to $2,000 annually for qualifying heat pump installations (inflation reduction act expansion)) ended for property placed in service after 2025-12-31 under the One Big Beautiful Bill Act (P.L. 119-21).
  • Section 25D Residential Clean Energy Credit (geothermal portion) (30% of installed cost for ground-source (geothermal) heat pumps, with no dollar cap) ended for property placed in service after 2025-12-31 under the One Big Beautiful Bill Act (P.L. 119-21).

Status as of 2026-09-19: neither 25C nor 25D has been reinstated or replaced by Congress. Pending bills (e.g. H.R. 616) have not advanced. Pre-2026 §25D installs may carry forward unused credits.

Rebate amounts and eligibility verified 2026-09-19 against primary program documentation. We re-check before any publish.

Get a quote using these rates

Mass Save contractors in nearby MA cities

Statewide guide & rebate references

See all HVAC services available in Boston in one place.

Frequently Asked Questions

How do I find a Mass Save contractor in Boston?
Find a Mass Save contractor in Boston by confirming HPIN enrollment on Mass Save's contractor finder and cross-referencing the Refrigeration Technician license with the state Bureau of Pipefitters, Refrigeration Technicians, and Sprinkler Fitters. Only an HPIN-enrolled Boston installer can file your heat pump rebate of up to $8,500.
Which Mass Save sponsor processes rebates in Boston?
Mass Save in Boston is administered through Eversource (electric) and National Grid (gas). That sponsor processes the heat pump rebate your HPIN contractor files — up to $8,500 standard, or up to $16,000 enhanced for income-qualified households in 2026 — plus the 0% HEAT Loan referral.
Who pulls the HVAC permit in Boston?
A qualified Boston contractor pulls the mechanical permit — and a separate gas permit for any gas work — through the Inspectional Services Department (ISD), Building Division. If an installer asks you to pull your own permit, it usually means they are not licensed to do the work in Boston.
What happens if I hire a non-HPIN installer in Boston?
You forfeit the Mass Save heat pump rebate of up to $8,500. In Boston, only a contractor enrolled in the Mass Save Heat Pump Installer Network can file the rebate paperwork, even when the equipment itself is on the qualified products list.

See your real cost after Mass Save rebates.

Connect with a vetted Massachusetts HPIN installer in minutes — no obligation.

1 About your project
2 Your contact info
About your project

No contact info needed yet. Two more fields and you're done.